Pls cadd will not snap to selected settings

This specifies the feature angle value for refinement up to the maximum level. Minimum Angle for Feature Detection (resolveMax Face Angle For Layer Generation (featureAngle)) Differences in mesh with different values for Buffer cell count The figure below shows the difference in volume mesh round the object with a Buffer Cell Count between Refinement Levels (nCellsBetweenLevels)В value of 1 and 3. Larger values like 5, will add more intermediate cell layers to gradually cover the refinement difference but greatly effect the mesh size. 1 means that if required only a single intermediate layer is added to match the refinement difference. This specifies the exact Number of buffer volume mesh cell layers between different levels of refinement. Buffer Cell Count between Refinement Levels (nCellsBetweenLevels) This specifies the maximum unbalance for processors in parallel meshing process. Max Processor Load Imbalance (maxLoadUnbalance) This setting will cause refinement to stop if cells to be refined are less than specified value Note: at least one iteration will be done, unless the number of cells to refine is 0. For instance the surface refinement algorithm might spend lots of iterations refining just a some cells. This specifies the minimum number of cells during the refinement phase. 16 or 32 Cell Limit for Refinement Termination (minRefinementCells) (for an expected large mesh size the meshing job with higher processors (higher RAM) should be selected e.g. The optimum value is between 10-15 million cells. This is the number of cells before removal of cells in castellated mesh step.

Pls cadd will not snap to selected settings